![]() ![]() To find your Raspberry Pi IP address, you can use Fing, AngryIPScanner or any other similar software. To access MotionEyeOS from your browser, you need the find the Raspberry Pi IP address. Wait a couple of minutes while it configures itself.Connect the power supply to power it up.You can remove after all the configuration has been completed. Temporarily connect a camera to the Raspberry Pi even if you don’t intend using one in the future. ![]() Connect the RJ45 ethernet cable to your network.Connect the SATA drive or any other drive you intend to use to store files.Follow these next steps to boot MotionEyeOS on your RPi 2 or 3: Use Etcher or Win32 Disk Imager to write the image onto the SD card.If you’re using the Raspberry Pi 3, choose. Choose and download the right image for your device: MotionEyeOS releases page.You can use the SD Card Formatter software. Burning MotionEye image to the microSD cardįollow the next steps to install MotionEyeOS on the microSD card for your Pi. You need to install MotionEyeOS on your Raspberry Pi, preferably a Raspberry Pi 2 or Raspberry Pi 3. In this setup, the power leads yellow/black are soldered directly to the back of the Raspberry Pi Zero board. The Raspberry Pi boards are being powered with a 12V DC 1500mA wallwart connected to 5A DC-DC converter set to around 5.2V output (this is a temporary setup for testing, after testing that everything is working fine, each Raspberry Pi Zero W should have a separated power supply). Each Raspberry Pi Zero W board is connected to a camera. The setup for the cameras consists of 4 Raspberry Pi Zero W with a Sandisk Ultra 16GB class 10. A friend of mine has suggested putting a beefy cap in parallel with the RPi power input Cameras Setup Note: I have found that my SATA drive is capable of being powered by the RPi 2 USB without a powered USB hub. Note: I have been doing some experimentation with powering RPi 2 and 3 and found that using a 12V 1500mA wallwart adapter and a 3 or 5A DC-DC converter with short leads seems more capable and often cheaper than a big 3A wallwart adapter, and gives you a 12V supply for other associated hardware. The Raspberry Pi is being powered with a 12VDC 1500mA wallwart connected to 2A DC-DC converter set to around 5.2V output. There is a 1TB SATA drive connected to the Pi with a SATA-USB cable. The Raspberry Pi Hub setup consists of a Raspberry Pi 2 Model B (if you have a RPi 3, use that board instead) with a Sandisk Ultra 16GB class 10. You can use the preceding links or go directly to /tools to find all the parts for your projects at the best price! 4x Standard micro usb 5V 2.5A power supply.4x MicroSD Card 8 or 16GB – the fastest you can afford.4x Raspberry Pi Camera (read What’s the Best Raspberry Pi Camera For Your Project?).4x Raspberry Pi Zero W (with built-in Wi-Fi).1x 5V power supply capable of powering both the Raspberry Pi and the SATA drive separately. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |